Turbo Systems Acura Integra Honda Civic Installation Instructions

Though this turbo grouping has been fashioned to use existing emissions controls (including catalytic converter), defect local laws regarding aftermarket limiting to expelling pressurized vehicles. Shift the turbocharger kit from its containerful and inspect for any manifest tangible impairment. All kit components are thoroughly inspected and carefully prepacked preceding to shipment from the manufactory. If any business impairment is manifest, contact your supplier and quest that they enation a demand with the shipper implicated. Be certain to reexamine the Turbo Scheme Parts Itemize to verify that you fuck all needful kit components to locomote. If any components in the parts leaning are wanting, communicate Turbonetics, Inc. Consumer Service, it is recommended to bed the people items:
• Honda / Acura personnel / reparation manual
• A huge tableland / assembly nearby
• Definitive action of automotive tools
• Plenitude of neighboring easy workspace
• The power to ascension the object (at lowest a hoof or two off the land)
• Compeer oil pan gasket or RTV sealant, oil filtrate and engine coolant
• NPT draw sealant enter

here

2009 HONDA RIDGELINE CORNER PROTECTORS INSTALLATION MANUAL

PARTS LIST : 4 Corner protectors, 4 Alcohol swabs.

TOOLS AND SUPPLIES REQUIRED : Shop towel, Isopropyl alcohol, Scale, Felt-tip pen, Masking tape, Rubber roller, (T/N MHLE54D).

INSTALLATION INSTRUCTIONS :

NOTE: Do not damage the body paint finish. This corner protector kit should be installed only if the ambient air temperature is 15°C (60°F) or above. Heat the protectors and bonding surfaces with a heat gun or heat pump if the ambient air temperature is below 15°C (60°F). Wash and wax the areas to be covered.Use a high quality paste wax. To allow the adhesive to cure, do not wash the vehicle for 24 hours.

Installing the Corner Protectors :

1. Using an alcohol swab, thoroughly clean the area on the left side of the front bumper where the corner protector will attach.

2. Using a scale and a felt-tip pen, measure and mark two locations on the front bumper.

3. Align and attach the masking tapes to the marks made on the front bumper.

4. Erase the marks you made on the front bumper.

5. Remove the adhesive backing from the corner protector. Check the back of the corner protector for the correct orientation.

6. Attach the corner protector to the front bumper by aligning it with the masking tapes as shown.

7. Using a rubber roller, apply pressure against the corner protector and roll from one end to the other.

8. Repeat steps 1 through 7 on the right side of the vehicle.

9. Using an alcohol swab, thoroughly clean the area on the left rear bumper where the corner protector will attach.

10. Using a scale and a felt-tip pen, measure and mark three locations on the rear bumper.

11. Align and attach masking tape to the marks made on the rear bumper.

12. Attach masking tape at the intersecting point of the seam on the rear bumper and the masking tape attached in step 11.

13. Measure and attach masking tape on the rear bumper as shown.

14. Erase the marks you made on the rear bumper.

15. Remove the adhesive backing from the corner protector. Check the back of the corner protector for the correct orientation.

16. Attach the corner protector to the rear bumper by aligning it with the masking tapes as shown.

17. Using a rubber roller, apply pressure against the corner protector and roll from one end to the other.

18. Repeat steps 9 through 17 on the right side of the vehicle.